Sony SRS XG500 Bluetooth Pairing Instructions

The -Bluetooth Pairing- button on the Sony SRS XG500 wireless speaker.

This post gives Sony SRS XG500 Bluetooth Pairing Instructions for this Extra Bass boombox speaker, to connect it with common Bluetooth devices. E.g. Including the iPhone, iPod Touch, and the iPad line of Apple phones, media players, and tablets along with Android devices as well.

Sony SRS XG500 Bluetooth Pairing Instructions: Step by Step

With your SRS XG500 speaker switched OFF (all top panel lams are dark), run through these directions to pair it to your source Bluetooth device. E.g. We use an iPad Air 3 tablet for this demo.

1. Go to the Home Screen on your Source Device

Firstly, press the Home button to reveal the smart device’s Home screen.

2. Find the Settings App

We found ours on the second page of the Home screen, as shown next.

The iOS -Home- screen, showing the -Settings- app icon.

3. Bring up the Settings App

Thirdly, touch the Settings app icon.

The smart device then shows the first page of its settings, as shown in the next step.

4. Go to the Bluetooth Settings Page to Continue with Sony SRS XG500 Bluetooth Pairing

Our Bluetooth Settings screen displays as follows. Note that our Bluetooth is ON here. But since our 500 is currently powered OFF (and so, is not in pairing mode), it does not show up in the Other Devices list. Also, we don’t see it in the My Devices list since we’ve never paired this speaker with our mobile device before.

The -Bluetooth Settings- screen, showing nothing discovered in the -Other Devices- section.

5. Turn On your Sony SRX XG500 Speaker

Turn on the 500 by fast pressing its Power button. See this, pointed at by the green arrow, in the next picture.

The -Power- button on the Sony SRS XG500 boombox speaker.

The speaker then boots, and its status lamp glows green, as we see in the next picture.

But since our iPad does not know about this speaker, the SRS XG500 will not pair with it automatically.

The -Power- lamp glowing green on the top of the speaker.

6. Put the SRS XG500 into Bluetooth Pairing Mode

Then, to see this BT speaker on your device, place it into pairing mode. To do that, press the Pairing button, and release after a quarter second.

Find the Pairing button.

The -Bluetooth Pairing- button.

Then the speaker emits a rise-fall beep. Also, the Bluetooth Status lamp begins flashing in a pulse-pulse-pause-pulse-pulse-pause pattern.

The flashing -Bluetooth- lamp.

7. Find the Speaker on your Mobile Device to Continue with Sony SRS XG500 Bluetooth Pairing

See the screen shot next. We found our 500, as we point at with the green arrow.

The Sony SRS XG500 boombox showing as Discovered on an iPad.

8. Pair with your Speaker

Tap the listed speaker in the discovered devices list.

Your mobile device then pairs with the XG500.

E.g. The the mobile device’s Bluetooth Settings screen might then change to look something like the following. Note the now-connected SRS XG500 entry, as pointed at by the green arrows in the next screenshot.

The XG500 showing as Connected.

9. Done with Sony SRS XG500 Bluetooth Pairing !

At last, we have now successfully paired the XG500 Bluetooth speaker with a common mobile tablet device. Thus, you can start enjoying your music on this speaker, which sounds much better than that in just about every smart phone or tablet.